HP HPE6-A69 Exam Prep Guide: Prep guide for the HPE6-A69 Exam
2024 New Preparation Guide of HP HPE6-A69 Exam
NEW QUESTION # 17
(Scenarios may contain multiple errors which may or may not Impact the solution) Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration, it is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows:
There is an error message staling "incompatible interface." Which interfaces are the cause of the error? (Select two.)
- A. 1/1/48 iGBaseT 100m Cat5e Transceiver
- B. 1/1/13 10GBaseT SFP+ 30m Cat6A Transceiver
- C. 1/1/49 40G QSFP+ 15m Active Optical Cable
- D. 1/1/12 10GBaseT SFP*+ 30m Cat6A Transceiver
- E. 1/1/50 40G QSFP+ 15m Active Optical Cable
Answer: C,E
NEW QUESTION # 18
A customer would like to utilize some ArubaOS-CX 8325 switches to discard unwanted traffic to the IP address 10 20.30 40.
You enter the following command on the switch:
Ip route 10.20.30.40/32 blac
What will be the result?
- A. The switch will discard packets to the destined host and create a tog message
- B. The switch will discard packets to the destined host and return ICMP error to the sender.
- C. The switch will not discard packets to the destined host
- D. The switch will discard packets to the destined host silently
Answer: D
NEW QUESTION # 19
A customer is migrating from a Cisco VSS system to an ArubaOS-CX VSX cluster in order to provide default gateway functionality, the local network administrator creates VLAN interfaces The network administrator then migrates successfully from Cisco to Aruba The next day a manager asks if the solution is redundant. The network administrator realizes that there is no redundancy on the default gateway functionality What is the preferred solution with the least amount of configuration and disturbance?
- A. For every VLAN interface, configure an active gateway IP with the same IP address as already present in the first VSX node Configure this on both switches
- B. For every VLAN Interface, configure a VRRP IP address with the same IP address as already present in the first VSX node. Configure this on both switches.
- C. Remove the IP address on every VLAN interface, and replace it with another one in the same subnet Configure VRRP with the default gateway address as virtual IP-address per VLAN.
- D. Remove the IP address on every VLAN interface, and replace it with another one in the same subnet Configure active gateway IP with the default gateway address on every VLAN interface on Doth switches
Answer: C
NEW QUESTION # 20
Refer to the exhibit.
Which statement is true?
- A. Q1 and S1 are applied to all interfaces.
- B. No default queues are changed
- C. Q1 and S1 are applied to all interfaces mat do not have a QoS override applied
- D. To be effective, both Q1 and S1 still need to be applied to Interfaces
Answer: B
NEW QUESTION # 21
You are working with a customer whos has a paw of Aruba 8325 switches configured for Multi-Chassis Link Aggregation The customer is complaining that users are experiencing intermittent packet drops. Which action should be taken to quickly aid you in identifying the cause?
- A. Enable debug of vri with "console" set as the destination
- B. Check the configured VLANs using "show vsx config-consistency"
- C. Setup a mirror session to niter packets for TCPDUMP analysis
- D. Setup a mirror session to generate a Tshark file.
Answer: B
NEW QUESTION # 22
A customer wants to verify the proposed configuration snippets to create a point-to-point link between Aruba Switch and a third-party switch.
Will this configuration work with static routing?
- A. No. the configuration will not work because the Aruba Switch does not have the "routing" command on it
- B. yes, the configuration should work fine and has no issues
- C. No. the configuration will not work, because the Aruba Switch does not have a locally reachable IP address from the third-party switch.
- D. No, the configuration will not work, because the Aruba Switch has an MTU mismatch which will prevent IP communication.
Answer: A
NEW QUESTION # 23
How Is voice Traffic prioritized correctly on ArubaOS-CX switches?
- A. By implementing TOS-profiles
- B. By attaching the QoS settings directly to device profiles
- C. By defining voice VLANs inside VLAN context
- D. By placing it in the strict priority queue
Answer: A
NEW QUESTION # 24
You have designed a new wired solution for a customer that uses gateways and Dynamic Segmentation Which statements about User-Based Tunneling are true? (Select two)
- A. In U8T, the switch performs user authentication.
- B. in UBT, the switch sends user role Information to Aruba Gateway
- C. in UBT, the Aruba Gateway performs user authentication
- D. In UBT, the Aruba Gateway assigns the Primary user role
- E. UBT is supported only with Aruba Gateway standalone
Answer: C,E
NEW QUESTION # 25
You have removed a member out of the ArubaOS-CX 6300 VSF configuration. The login to the removed member falls. What is true about switch login recovery?
- A. The task requires physical access to the switch
- B. The zeroize task will remove all user passwords: the configuration remains on the switch
- C. The zeroize task executes the zeroize.txt from the root of the CF card on the switch
- D. The task can be executed remotely
Answer: A
NEW QUESTION # 26
With the given topology, the customer Has ArubaOS-CX 6300 switches and Aruba Gateway in use.
What is required for the client traffic to be tunneled as per best practice between the connected switch port and the Aruba Gateway'' (Select two.)
- A. The ArubaOS-CX switch and Aruba gateway should be EBGP peers.
- B. IP Protocol 6 should not be blocked on me datapath
- C. IP Protocol 47 should not be blocked in the data-path
- D. The ArubaOS-CX switch and Aruba gateway should have an end-to-end MacSec connection
- E. Change the default MTU on the data-path between the switch and gateway
Answer: D,E
NEW QUESTION # 27
The customer has a requirement for creating security filtering for IPv4 and IPv6 traffic passing through an ArubaOS-CX 6400 switch. Which statement Is true about access-list on the selected switch model?
- A. IPv4 and IPv6 entries can be used in one ACL with separate rules
- B. Only one inbound or outbound ACL can be bound to an interface.
- C. Separate IPv4 and IPv6 ACLs need to be created for inbound and outbound traffic
- D. Routed interfaces can have only inbound ACLs
Answer: D
NEW QUESTION # 28
Which statement is true regarding remote mirroring?
- A. Per session multiple destination addresses can be configured
- B. The ArubaOS-CX switch supports a maximum of two mirroring sessions
- C. The same source/destination address can be used in multiple sessions.
- D. When mirroring destination is tunnel, a DSCP value can be set on the tunnel
Answer: A
NEW QUESTION # 29
After a Proof of Concept where NetEdit was used to troubleshoot the network, the customer agrees that NetEdit meets some of its technical goals.
Which technical goals does NetEdit meet? (Select two.)
- A. improve reliability of mission-critical applications
- B. improve the network throughput
- C. Minimize network downtime
- D. Simplify network management
- E. improve the network's scalability
Answer: A,C
NEW QUESTION # 30
Which statement is true regarding IP-SLA?
- A. ArubaOS-CX supports on-demand as well as forever tests.
- B. ArubaOS-CX supports forever tests
- C. ArubaOS-CX supports Doth SLA configuration through CU and by agents through the NAE.
- D. The default and minimum probe interval for voip SLA is 180 seconds
Answer: B
NEW QUESTION # 31
Refer to the exhibit.
A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?
- A. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.
- B. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports
- C. Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.
- D. Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.
Answer: A
NEW QUESTION # 32
What are two valid steps in a Proof of Concept plan? (Select two)
- A. Development of the items to Be tested
- B. Engineering a proposed solution
- C. Acceptance of the proposed solution
- D. Definition of success criteria
Answer: A,D
NEW QUESTION # 33
When applying me following access-Iist to an ArubaOS-CX 6300 switch:
How does this ACL behave on the selected switch? (Select two.)
- A. The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
- B. The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs
- C. The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
- D. The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
- E. The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
Answer: B,C
NEW QUESTION # 34
With the given access-list:
Which statement is true about hardware resource consumption of this ACL?
- A. The ACL consumes a total of 4 entries.
- B. The ACL consumes a total of 8 entries.
- C. The ACL consumes a total of 2 entries
- D. The ACL consumes a total of 6 entries.
Answer: D
NEW QUESTION # 35
The customer is implementing new ArubaOS-CX 6300 switches into an environment that has third-party switches and uses centralized authentication from Microsoft Active Directory and TACACS* servers What would be a valid configuration requirement for ArubaOS-CX switches for centralized user authentication?
- A. Importing a TACACS server certificate for TLS authentication into the switch
- B. Using a PAM extension for LDAP authentication with Active Directory Server.
- C. Enabling the active directory VSA in the switch for radius authentication
- D. Defining a TACACS server group for authentication in the switch configuration
Answer: C
NEW QUESTION # 36
Which statement is true about NAE scripts'?
- A. The System Resource Monitor is the only script Installed on the system by default.
- B. No script is installed on the system by default.
- C. The System Resource Monitor and Health Monitor a/e the only scripts installed on the system by default
- D. The Health Monitor is the only script installed on the system by default.
Answer: A
NEW QUESTION # 37
......
HPE6-A69 exam consists of 60 multiple-choice questions that must be completed within a time limit of 90 minutes. Candidates must achieve a minimum score of 75% to pass the exam and become certified. Aruba Certified Switching Expert Written Exam certification is recognized by industry professionals worldwide and is highly respected in the field of networking and switching. The Aruba Certified Switching Expert certification provides professionals with the skills and knowledge needed to design, implement, and troubleshoot complex Aruba switching environments.
Latest Questions HPE6-A69 Guide to Prepare Free Practice Tests: https://testking.guidetorrent.com/HPE6-A69-dumps-questions.html