[Apr-2024] Free NSE7_SDW-7.0 Exam Dumps to Improve Exam Score
2024 Realistic NSE7_SDW-7.0 Dumps Exam Tips Test Pdf Exam Material
Fortinet NSE7_SDW-7.0 exam is a certification exam designed to test the knowledge and skills of network security professionals in the area of software-defined wide area networking (SD-WAN). NSE7_SDW-7.0 exam is part of the Fortinet Network Security Expert (NSE) program, which is a certification program designed to recognize and validate the skills and expertise of network security professionals. The NSE7_SDW-7.0 exam is designed to test the knowledge and skills of candidates in the area of SD-WAN technology, including concepts such as WAN optimization, network security, and application performance.
NEW QUESTION # 42
In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose two.)
- A. It provides direct connectivity between spokes by creating shortcuts.
- B. It provides the benefits of a full-mesh topology in a hub-and-spoke network.
- C. It enables spokes to establish shortcuts to third-party gateways.
- D. It enables spokes to bypass the hub during shortcut negotiation.
Answer: A,B
NEW QUESTION # 43
Refer to the exhibit.
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?
- A. All traffic from a source IP is sent to the same interface.
- B. All traffic from a source IP to a destination IP is sent to the same interface.
- C. All traffic from a source IP is sent to the most used interface.
- D. All traffic from a source IP to a destination IP is sent to the least used interface.
Answer: B
NEW QUESTION # 44
Refer to the exhibit.
Which statement explains the output shown in the exhibit?
- A. FortiGate must re-evaluate the session due to routing change.
- B. FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.
- C. FortiGate performed standard FIB routing on the session.
- D. FortiGate will not re-evaluate the session following a firewall policy change.
Answer: A
NEW QUESTION # 45
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set cost 15.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B,D
NEW QUESTION # 46
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Reverse-policy shaping mode
- B. Shared-policy shaping mode
- C. Per-IP shaping mode
- D. Interface-based shaping mode
Answer: D
Explanation:
Explanation
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 47
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the source NAT (SNAT) global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two actions does FortiGate perform on existing sessions established over port2, if the administrator increases the static route priority on port2 to 20? (Choose two.)
- A. FortiGate updates the gateway information of the sessions with SNAT so that they use port1 instead of port2.
- B. FortiGate flags the sessions as dirty.
- C. FortiGate continues routing the sessions with no SNAT, over port2.
- D. FortiGate performs a route lookup for the original traffic only.
Answer: A,B
NEW QUESTION # 48
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- B. All SD-WAN rules have the default setting enabled.
- C. The sdwan_service_id flag in the session information is 0.
- D. Traffic does not match any of the entries in the policy route table.
Answer: C,D
Explanation:
sdwan_service_id is 0 = match SD-WAN implicit rule, study guide 7.0 page 120, 7.2 page 149 SD-WAN rules internally are interpreted as a Policy route, so when the traffic doesn't match with any policy route, it will be flowing by implict policy.
NEW QUESTION # 49
Refer to the exhibit.
The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)
- A. The main session cannot be offloaded to hardware.
- B. The reply direction of the asymmetric traffic flows from port2 to port3.
- C. The auxiliary session can be offloaded to hardware.
- D. The original direction of the symmetric traffic flows from port3 to port2.
Answer: B,C
NEW QUESTION # 50
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
- B. Application control must be enabled on the firewall policy.
- C. Web filtering must be enabled on the firewall policy.
- D. Destination internet service must be enabled on the traffic shaping policy.
Answer: B
NEW QUESTION # 51
Refer to the exhibit.
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
Which two configuration settings are required for Toronto and London spokes to establish an ADVPN shortcut? (Choose two.)
- A. On the spokes, auto-discovery-receiver must be enabled on the IPsec VPN to the hub.
- B. On the hubs, auto-discovery-sender must be enabled on the IPsec VPNs to spokes.
- C. On the hubs, net-device must be enabled on all IPsec VPNs.
- D. auto-discovery-forwarder must be enabled on all IPsec VPNs.
Answer: A,B
NEW QUESTION # 52
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure interfaces as SD-WAN members without having to remove references first.
- B. You can configure advanced CLI settings.
- C. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- D. You can reference meta fields.
Answer: B,D
NEW QUESTION # 53
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)
- A. Security Association (SA)
- B. Internet Key Exchange (IKE)
- C. Secure Shell (SSH)
- D. Encapsulating Security Payload (ESP)
Answer: B,D
NEW QUESTION # 54
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)
- A. Non-TCP Facebook and YouTube traffic are not used for performance measurement.
- B. FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
- C. FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.
- D. The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
Answer: A,D
Explanation:
Study Guide 7.0, pages 88 - 89.
Study Guide 7.2, pages 103 - 104.
Another comment said "because without using application Control on the firewall policy, SDWAN can't work" but there is a app control "default" defined on config.
NEW QUESTION # 55
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The zero-touch provisioning process has completed internally, behind FortiGate.
- B. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- C. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- D. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- E. A factory reset performed on FortiGate.
Answer: A,C
NEW QUESTION # 56
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. diagnose debug application ike
- B. get router info routing-table all
- C. diagnose vpn tunnel list
- D. get ipsec tunnel list
Answer: A
Explanation:
IKE real-time debug - useful when debugging ADVPN shortcut messages and spoke-to-spoke negotiations.
* diagnose debug console timestamp enable
* diagnose vpn ike log filter clear
* diagnose vpn ike log filter mdst-addr4 <ip.of.hub> <ip.of.spoke>
* diagnose debug application ike -1
* diagnose debug enable
NEW QUESTION # 57
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process?
(Choose two.)
- A. The zero-touch provisioning process has completed internally, behind FortiGate.
- B. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- C. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- D. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- E. A factory reset performed on FortiGate.
Answer: A,C
NEW QUESTION # 58
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
- A. When T_N1PLS_0 has a latency of 80 ms.
- B. When T_INET_0_0 has a latency of 250 ms.
- C. When T_MPLS_0 has a latency of 100 ms.
- D. When T_INET_0_0 and T_MPLS_0 have the same latency.
Answer: A
NEW QUESTION # 59
Refer to the exhibit.
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?
- A. All traffic from a source IP is sent to the same interface.
- B. All traffic from a source IP to a destination IP is sent to the same interface.
- C. All traffic from a source IP is sent to the most used interface.
- D. All traffic from a source IP to a destination IP is sent to the least used interface.
Answer: B
NEW QUESTION # 60
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan sla-log
- B. diagnose sys sdwan intf-sla-log
- C. diagnose sys sdwan health-check
- D. diagnose sys sdwan log
Answer: A
NEW QUESTION # 61
Which two statements about SD-WAN central management are true? (Choose two.)
- A. It does not support meta fields.
- B. The objects are saved in the ADOM common object database.
- C. It uses templates to configure SD-WAN on managed devices.
- D. It supports normalized interfaces for SD-WAN member configuration.
Answer: B,C
Explanation:
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-fmg
NEW QUESTION # 62
Which two interfaces are considered overlay links? (Choose two.)
- A. IPsec
- B. LAG
- C. GRE
- D. Physical
Answer: A,C
NEW QUESTION # 63
Exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- B. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- C. The packet size exceeded the outgoing interface MTU.
- D. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
Answer: D
NEW QUESTION # 64
......
Powerful NSE7_SDW-7.0 PDF Dumps for NSE7_SDW-7.0 Questions: https://testking.guidetorrent.com/NSE7_SDW-7.0-dumps-questions.html